LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
    2. Fig 1: Identifying Evaporative Emission (EVAP) Canister Vent Solenoid Valve
    GM1396038Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) canister vent solenoid harness connector.
  3. Remove the EVAP vent hose from EVAP canister solenoid.
  4. Depress the EVAP canister vent bracket tab to release the EVAP canister vent solenoid.
  5. Remove the EVAP canister solenoid from the fuel tank.
scientia non olet · About LEMON Manuals