LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.
    2. Fig 1: View Of Right CMP Actuator Valve - Exhaust
    GM1285202Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP actuator valve.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Right CMP Actuator Valve Electrical Connector - Exhaust
    GM1285201Courtesy of GENERAL MOTORS CORP.
  4. Install the CMP valve electrical connector.
scientia non olet · About LEMON Manuals