LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Cleaner Bolts
    GM1404635Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner with the MAF sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the air cleaner bolts.

    Tighten:  Tighten the air cleaner bolts to 10 N.m (89 lb in).

  3. Install the TCM with the wiring harness to the air cleaner.
  4. Connect the MAF sensor electrical connector.
    5. Fig 2: View Of Air Cleaner Upper Cover
    GM1404634Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner upper cover and the upper cover bolts.

    Tighten:  Tighten the air cleaner upper cover bolts to 4 N.m (35 lb in).

  6. Install the air inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (LY7) .
scientia non olet · About LEMON Manuals