LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Hinge Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to PAINT DAMAGE NOTICE .
  1. Apply masking tape to the door edge.
    2. IMPORTANT: Do not remove the door from the vehicle to replace the upper or the lower hinges.
  2. Open the front door to expose the rear door hinges. Do not open the door to replace the hinges.
  3. Clean the area around the hinge and mark the location with a grease pencil.
    4. Fig 1: Identifying Rear Door Hinge Bolts
    GM1363632Courtesy of GENERAL MOTORS CORP.
  4. If the upper hinge is broken, remove the upper hinge bolts from the door side in the specified sequence (1, 4).
    5. Fig 2: Identifying Hinge Pillar Side Bolts (Rear Door)
    GM800995Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper hinge bolts from the hinge pillar side in the specified sequence (1, 4).
    6. Fig 3: View Of Lower Hinge Bolts
    GM1362780Courtesy of GENERAL MOTORS CORP.
  6. If the lower hinge is broken, remove the lower hinge bolts from the door side in the specified sequence (3, 2).
    7. Fig 4: Identifying Hinge Pillar Side Bolts (Rear Door)
    GM800995Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower hinge bolts from the hinge pillar side in the specified sequence (3, 2).
  8. Remove the broken hinge from the door.
scientia non olet · About LEMON Manuals