Removal Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Apply masking tape to the door edges.
- Open the rear door.
- Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Remove the rear door inner sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Remove the front of the rear door frame applique and the rear. Refer to Rear Door Frame Applique Replacement .
- Remove the rear door outer sealing strip. Refer to Rear Door Window Belt Outer Sealing Strip Replacement .
- Remove the rear door window. Refer to Rear Side Door Window Replacement .
- Remove the rear door lock. Refer to Rear Door Lock Replacement .
- Remove the rear door outside door handle. Refer to Rear Side Door Outside Handle Replacement .
- Remove the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .
- Remove the rear door window channel retainer. Refer to Rear Side Door Window Channel Retainer Replacement .
- Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement .
- Remove the rear door rubber conduit. Refer to Front Side Door Conduit Replacement .
- Disconnect the rear door wiring harness.
- Remove the rear door electrical harness from the door.
- Support the rear door.
- Remove the rear door top intermediate bolt from the door side hinge.
- Remove the rear door lower hinge bolts from the door side (1).
- Remove the rear door from the vehicle.