Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear door to vehicle.
- Install the rear door top intermediate bolt to the door hinge.
Tighten: Tighten the bolts to 33 N.m (24 lb ft).
- Install the rear door lower hinge bolts (1) to the door side (1).
Tighten: Tighten the bolts to 33 N.m (24 lb ft).
- Remove the rear door support.
- Install the rear door rubber conduit. Refer to Rear Side Door Conduit Replacement .
- Install the rear door electrical harness.
- Connect the rear door wiring harness.
- Install the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement .
- Install the rear door window channel retainer. Refer to Rear Side Door Window Channel Retainer Replacement .
- Install the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .
- Install the rear door outside door handle. Refer to Rear Side Door Outside Handle Replacement .
- Install the rear door lock. Refer to Rear Door Lock Replacement .
- Install the rear door window. Refer to Rear Side Door Window Replacement .
- Install the rear door inner sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Install the rear door outer sealing strip. Refer to Rear Door Window Belt Outer Sealing Strip Replacement .
- Install the front of the rear door frame applique and the rear. Refer to Rear Door Frame Applique Replacement .
- Install the rubber conduit. Refer to Rear Side Door Conduit Replacement .
- Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Adjust the rear door. Refer to Rear Door Adjustment .
- Close the rear door.
- Remove the masking tape from the rear door edges.
NOTE:
Refer to Fastener Notice
.