LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Opening Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Door Opening Weatherstrip
    GM164727Courtesy of GENERAL MOTORS CORP.
  1. Install the weatherstrip to the door opening.
    1. Start in the center bottom of the pinch-weld flange.
    2. Push the weatherstrip and retainers on the flange.
    3. Ensure that the weatherstrip and retainers are fully seated on the flange before installing the rear carpet retainer.
  2. Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement .
  3. Install the rear quarter lower trim. Refer to Rear Quarter Lower Trim Panel Replacement .
  4. Inspect the door for proper operation.
  5. Close the door.
scientia non olet · About LEMON Manuals