LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Door Hinge Bolts
    GM1363632Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the door side hinge bolts in the specified sequence (1, 2, 3, 4).

    Tighten:  Tighten the bolts to 33 N.m (24 lb ft).

  2. Inspect the door for proper operation and alignment.
  3. Remove the masking tape.


    Fig 1: Identifying Hinge Pillar Side Bolts (Rear Door)
    GM800995Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the hinge pillar side bolts in the specified sequence (1, 2, 3, 4).

    Tighten:  Tighten the bolts to 33 N.m (24 lb ft).

  2. Inspect the door for proper operation and alignment.
  3. Remove the masking tape.
scientia non olet · About LEMON Manuals