LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Compartment Lid Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hinge to the alignment marks that was made on the quarter panel.
    2. Fig 1: Identifying Rear Compartment Hinge
    GM324455Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts that attach the hinge to the rear quarter.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the rear compartment struts. Refer to Rear Compartment Lid Strut Replacement .
  4. Install the rear compartment lid nuts. Refer to Rear Compartment Lid Replacement .
  5. Adjust the rear compartment lid height:
    • Use an Allen wrench to turn the rear compartment hinge height adjustment bumper.
    • Turn the rear compartment lid bumper by hand.
  6. Close the rear compartment.
scientia non olet · About LEMON Manuals