LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Rear Outer Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Side Hood Seal
    GM456730Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Remove the rear side hood seal from the pinchweld flange and motor compartment flange.
  3. Remove the rear side hood seal from the vehicle.
  4. Clean any adhesive from the pinch-weld flange and motor compartment flange surface using 3M™ P/N 8984 Adhesive Remover.
scientia non olet · About LEMON Manuals