LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Rear Outer Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Side Hood Seal
    GM456730Courtesy of GENERAL MOTORS CORP.
  1. Remove the protective backing paper from the adhesive on the rear side hood seal.
  2. Install the rear side hood seal to the pinchweld flange and motor compartment flange.
  3. Install the side rear hood seal onto the pinch-weld flange and motor compartment flange until the adhesive is fully adhered.
  4. Close the hood.
scientia non olet · About LEMON Manuals