LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Filler Pocket
    GM490003Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel filler pocket to the fuel filer neck.
  2. Press in until the fuel filler pocket is fully seated to the quarter panel.
    3. NOTE: Refer to Fastener Notice .
    Fig 2: Identifying Fuel Filler Pocket Bolts
    GM490004Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts.

    Tighten:  Tighten the fuel filler neck bolts to 5 N.m (44 lb in).

  4. Remove all tape from fuel filler pocket opening.
  5. Replace the fuel filler cap.
  6. Close the fuel filler door.
scientia non olet · About LEMON Manuals