LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Conduit Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Door Rubber Conduit
    GM308354Courtesy of GENERAL MOTORS CORP.
  1. Open the front door.
  2. Remove the rubber conduit (1) from where it attaches at the front pillar.
  3. Carefully pull the wire harness out from the front pillar to expose the harness connector.
  4. Disconnect the door wiring harness electrical connector.
  5. Remove the rubber conduit from the door and remove it from the electrical harness.
scientia non olet · About LEMON Manuals