LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Adjustment >> Up/Down or In/Out Adjustment

Up/Down or In/Out Adjustment

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position.
    Fig 1: Identifying Front Door Hinge
    GM315802Courtesy of GENERAL MOTORS CORP.
  1. Loosen the bolts on the door side upper and lower hinges. Do not remove the bolts.
  2. Adjust the door up or down by repositioning the door as needed.
  3. Adjust the door in or out by repositioning the door as needed.
  4. NOTE: Refer to Fastener Notice .
  5. Tighten the door side upper and lower hinge bolts.

    Tighten:  Tighten the bolts to 33 N.m (24 lb ft).