Circuit/System Testing
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the rear compartment courtesy lamp.
- Ignition ON, verify a test lamp illuminates between the control circuit terminal A and ground.
- If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- Ignition OFF, connect the harness connector at the rear compartment courtesy lamp. Disconnect the harness connector at the rear compartment lid latch.
- Test for less than 10 ohms of resistance between the ground circuit terminal 3 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify the rear compartment courtesy lamp is not illuminated.
- If the rear compartment courtesy lamp is illuminated, test the control circuit terminal 1 for a short to ground.
- Install a 5A fused jumper wire between the control circuit terminal 1 and ground. Verify the rear compartment courtesy lamp is illuminated.
- If the rear compartment courtesy lamp does not illuminate, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the test the rear compartment courtesy lamp bulb.
- If all circuits test normal, test or replace the rear compartment lid latch.