Circuit/System Verification
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the I/P dimming lamps while commanding the Incandescent Dimming ON and OFF with a scan tool. The I/P dimming lamps should turn ON and OFF when changing between the commanded states.
- If any of the lamps do not turn ON and OFF when commanded, refer to I/P Dimming Lamps Circuit Test in Circuit/System Testing .
- Observe the I/P dimming lamps while operating the dimmer switch from high to low. The lamps should smoothly vary in brightness as the switch is rotated.
- If the lamps do not smoothly vary in brightness as the switch is rotated, refer to Dimmer Switch Circuit Test in Circuit/System Testing .