LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC P0572 or P0573 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

When the brake pedal is applied, the BCM receives a brake applied signal from the brake pedal position sensor (BPPS). The BCM applies B+ to the stop lamp switch signal circuit. This circuit supplies a B+ signal to the powertrain control module (PCM) (L26), engine control module (ECM) (LY7), transmission control module (TCM) (LY7), throttle actuator control (TAC) module, and electronic brake control module (EBCM) indicating the brakes are applied. B+ is also supplied to the center high mound stop lamp (CHMSL), illuminating it when the brakes are depressed.

scientia non olet · About LEMON Manuals