LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
    3. Fig 1: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
  3. Remove the bearing retainer using J 23653-SIR  and J 42137  and dispose of it. See Special Tools .
  4. Remove J 23653-SIR  and J 42137  from the steering shaft assembly. See Special Tools .
    5. Fig 2: View of Shaft Lock Shield Assembly, Turn Signal Cancel Cam Assembly, Upper Bearing Spring, Bearing Inner Race Seat and Inner Race
    GM665288Courtesy of GENERAL MOTORS CORP.
  5. Remove the shaft lock shield assembly (1).
  6. Remove the turn signal cancel cam assembly (2).
  7. Remove the upper bearing spring (3).
  8. Remove the upper bearing inner race seat (4).
  9. Remove the inner race (5).
scientia non olet · About LEMON Manuals