LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Inner Race, Upper Bearing Inner Race Seat, Upper Bearing Spring, and Turn Signal Cancel Cam Assembly
    GM420188Courtesy of GENERAL MOTORS CORP.
  1. Install the inner race (4).
  2. Install the upper bearing inner race seat (3).
  3. Install the upper bearing spring (2).
  4. Lubricate the turn signal cancel cam assembly (1) with GM P/N 12377900 (Canadian P/N 10953529).
  5. Install the turn signal cancel cam assembly (1).
    6. Fig 2: View of Shaft Lock Shield Assembly
    GM665298Courtesy of GENERAL MOTORS CORP.
  6. Install the shaft lock shield assembly.
    7. Fig 3: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
  7. Install the new bearing retainer using J 23653-SIR  and J 42137  . See Special Tools .
  8. Remove J 23653-SIR  and J 42137  from the steering shaft assembly. See Special Tools .
  9. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals