LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  1. Route the SIR connector through the steering wheel.
  2. Align the scribe mark on the steering wheel with the slash mark on the steering shaft.
  3. Install the steering wheel.
    4. NOTE: Refer to Fastener Notice .
  4. Install the steering shaft nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  5. Install the Inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Inspect the operation of the following components:
    • The horn
    • The steering wheel
    • The steering wheel controls
scientia non olet · About LEMON Manuals