LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Bearing Adapter
    GM1562298Courtesy of GENERAL MOTORS CORP.
  1. Install the adapter and bearing assembly to the steering jacket assembly.
    2. Fig 2: Identifying Lower Steering Column Components
    GM420221Courtesy of GENERAL MOTORS CORP.
  2. Install the following onto the steering shaft:
    1. The steering wheel position sensor (1) Refer to Steering Wheel Position Sensor Centering .
    2. The sensor locator (2)
    3. The sensor retainer (3)
    4. The steering shaft seal (4)
    5. The boot seal (5)
  3. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals