LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Wiring Harness Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column And Wire Harness Assembly
    GM603937Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
    IMPORTANT: Check the main wiring harness assembly for burned 2 amp fuses before doing this procedure.
  1. Disable the SIR coil. Refer to SIR Disabling and Enabling .
  2. Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
  3. Remove the steering column from the vehicle. Refer to Steering Column Replacement .
  4. Inspect the steering column for accident damage. Refer to Steering Column Accident Damage Inspection .
  5. Remove the upper and lower trim cover. Refer to Steering Column Trim Covers Replacement .
  6. Disconnect all connectors attached to the wire harness assembly.
  7. Remove the bulkhead connector.
scientia non olet · About LEMON Manuals