LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Wiring Harness Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column And Wire Harness Assembly
    GM603937Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION .
  1. Slide the bulkhead connector into the steering column.
  2. Connect all of the connectors to the wire harness assembly.
  3. Install the upper and lower trim cover. Refer to Steering Column Trim Covers Replacement .
  4. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  5. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals