LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Steering Column Trim Cover
    GM1702769Courtesy of GENERAL MOTORS CORP.
  1. If necessary, install the upper steering column trim cover to the closeout trim cover.
  2. Install the upper trim cover to the steering column.
  3. Install the ignition lock cylinder.
    4. Fig 2: View Of Lower Trim Cover
    GM1702768Courtesy of GENERAL MOTORS CORP.
  4. Install the lower trim cover and ensure that the tabs engage with the tabs on the upper trim cover.

    Snap the tabs together.

  5. Connect the lower steering column trim cover to the closeout trim cover.
    6. Fig 3: View Of Tilt Lever
    GM603840Courtesy of GENERAL MOTORS CORP.
  6. Install the tilt lever (1).
  7. Install the gap hider. Refer to Instrument Cluster Replacement .
  8. Install the knee bolster. Refer to Driver Knee Bolster Replacement .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
  11. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals