LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shift Lever, Seal (Boot), Screw & Upper Trim Cover
    GM419648Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Slide the shift lever seal (2) up the shift lever (4).
  3. If necessary, remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Disconnect the shift lever connector at the base of the column.
  5. Remove the shift lever screw (3) from the shift lever assembly (4).
  6. Remove the shift lever and seal from the linear shift assembly.
    7. IMPORTANT: The shift lever seal must be removed by sliding the shift lever seal towards the narrow section of the shift lever.
  7. Remove the shift lever seal (2) from the shift lever (4).
scientia non olet · About LEMON Manuals