LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shift Lever, Seal (Boot), Screw & Upper Trim Cover
    GM419648Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The shift lever seal must be installed to the narrow end of the shift lever.
  1. Install the shift lever seal (2) onto the shift lever assembly (4).
  2. Install the shift lever assembly (4) to linear shift assembly.
    3. NOTE: Refer to Fastener Notice .
  3. Install the shift lever screw (3) into the shift lever assembly (4).

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  4. Slide the shift lever seal (2) down the shift lever assembly (4).
  5. Align the shift lever seal into the steering column trim covers.
  6. If necessary, install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals