LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the intermediate steering shaft into the seal.
    2. Fig 1: View Of Upper Pinch Bolt Of Intermediate Steering Shaft
    GM454259Courtesy of GENERAL MOTORS CORP.
  2. Connect the intermediate shaft to the steering column as noted during removal.
  3. Install the upper boot to the ridge around the intermediate shaft pass-through.
    4. NOTE: Refer to Fastener Notice .
  4. Install the upper intermediate steering shaft pinch bolt.

    Tighten:  Tighten the pinch bolt to 48 N.m (35 lb ft).

  5. Connect the intermediate steering shaft seal onto the steering column.
  6. Raise the vehicle.
    7. Fig 2: View Of Lower Intermediate Shaft Seal To Steering Gear
    GM1206804Courtesy of GENERAL MOTORS CORP.
  7. Connect the intermediate steering shaft to the power steering gear stub shaft as noted during removal.
  8. Install the lower intermediate steering shaft pinch bolt.

    Tighten:  Tighten the pinch bolt to 48 N.m (35 lb ft).

  9. Connect the intermediate steering shaft seal onto the power steering gear. Rotate the lower seal as necessary to gain maximum clearance.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals