LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (HVAC System - Manual) >> Repair Instructions >> Heater and Air Conditioning Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel lower trim plate. Refer to Instrument Panel Lower Trim Plate Replacement .
    2. Fig 1: Identifying HVAC Control Assembly Mounting Screws
    GM1397121Courtesy of GENERAL MOTORS CORP.
  2. Remove the HVAC control assembly mounting screws (1).
    3. Fig 2: Identifying HVAC Control Assembly
    GM1397027Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Retaining clips hold the HVAC control assembly in place.
  3. Pull the HVAC control assembly rearward from the instrument panel.
  4. Disconnect the electrical connectors form the HVAC control assembly.
  5. Remove the HVAC control assembly.
scientia non olet · About LEMON Manuals