LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (HVAC System - Automatic) >> Repair Instructions >> Air Temperature Actuator Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Left Air Temperature Actuator
    GM833461Courtesy of GENERAL MOTORS CORP.
  1. Position the left air temperature actuator. Align the slots in the electric actuator driver to the flats on the shaft.
  2. Align the locating hole to the alignment pin on the HVAC module case.
  3. Slide the actuator on the shaft. The actuator driver should seat completely onto the shaft and the mounting holes should be flush with the mounting screws on the HVAC module case.
    4. NOTE: Refer to Fastener Notice .
  4. Install the mounting screws to the left air temperature actuator.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  5. Connect the electrical connector to the left air temperature actuator.
  6. Install the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  7. Calibrate the actuator. Refer to Actuator Recalibration .
scientia non olet · About LEMON Manuals