LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Replacement (L26) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Remove the drive belts. Refer to Drive Belt Replacement (L26) .
  3. Remove the splash shield from the right side of the engine. Refer to Engine Splash Shield Replacement .
  4. Remove the hose nut from the A/C compressor.
  5. Remove the hose from the A/C compressor.
    IMPORTANT: Remove and discard all sealing washers.
  6. Disconnect the electrical connector from the A/C compressor.
    7. Fig 1: View Of A/C Compressor
    GM1199944Courtesy of GENERAL MOTORS CORP.
  7. Loosen the rear mounting bolt from the A/C compressor.
  8. Remove the front mounting bolt from the A/C compressor.
  9. Remove the front mounting nut from the A/C compressor.
  10. Remove the A/C compressor.
    11. IMPORTANT: Replacement compressors are shipped with polyalkylene glycol (PAG) oil.
  11. If replacing the compressor, balance the compressor oil. Refer to Compressor Oil Balancing .
scientia non olet · About LEMON Manuals