LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice .
  1. Install the compressor drain plug.

    Tighten:  Tighten the drain plug to 16 N.m (12 lb ft).

  2. Position the A/C compressor onto the front A/C compressor mounting stud and the rear A/C compressor mounting bolt.
  3. Install the A/C compressor front bolt.

    Tighten:  Tighten the bolts to 50 N.m (36 lb ft).

  4. Install the A/C compressor front mounting nut.

    Tighten:  Tighten the nut to 50 N.m (36 lb ft).

  5. Tighten the A/C compressor rear bolt.

    Tighten:  Tighten the bolt to 50 N.m (36 lb ft).

  6. Install new sealing washers. Refer to Sealing Washer Replacement .
    7. Fig 1: View Of A/C Compressor
    GM1199944Courtesy of GENERAL MOTORS CORP.
  7. Install the hose to the A/C compressor.
  8. Install the nut to the A/C compressor hose.

    Tighten:  Tighten the nut to 17 N.m (12.5 lb ft).

  9. Connect the electrical connector to the A/C compressor.
  10. Install the splash shield to the right side of the engine. Refer to Engine Splash Shield Replacement .
  11. Install the drive belts. Refer to Drive Belt Replacement (L26) .
  12. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  13. Leak test the fittings of the component using J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals