Removal Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accessory drive belt from the A/C compressor. Refer to Drive Belt Replacement (L26) for the 3.8L (L26) engine or Drive Belt Replacement for the 3.6L (LY7) engine, or Drive Belt Replacement - Accessory for the 5.3L (LS4) engine.
- Remove the compressor. Refer to Compressor Replacement (L26) or Compressor Replacement (LY7) or Compressor Replacement (LS4) .
- Remove the lower air deflector. Refer to Radiator Air Lower Baffle and Deflector Replacement .
- Remove and discard the compressor clutch plate bolt.
Use the J 37872 to hold the compressor clutch plate from turning. See Special Tools .
- Remove the compressor clutch plate from the compressor.
- Remove the compressor pulley snap ring using the J 6083 . See Special Tools .
- Remove the compressor pulley from the compressor.
- Remove the compressor clutch coil snap ring using the J 6083 . See Special Tools .
- Remove the compressor clutch coil from the compressor.
IMPORTANT:
Remove the 3 adjustable dowels from J 37872
. See Special Tools .
Install three 5/16x1 inch bolts in place of the dowels.
Install three 5/16x1 inch bolts in place of the dowels.