LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Instrument Panel System Displays & Gages) >> Diagnostic Information and Procedures >> DTC P0462 (2.8L, 3.0L, 3.2L and 3.6L Engines) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. While sweeping the fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms of resistance between signal terminal B and the low reference terminal C.
    • If not within the specified range, replace the fuel level sensor.
scientia non olet · About LEMON Manuals