LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Sunroof System) >> Repair Instructions >> Sunroof Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Module Electrical Connector
    GM647217Courtesy of GENERAL MOTORS CORP.
  1. Align the wire harness to the sunroof module.
  2. Connect the electrical connectors to the following components:
    • The sunroof control switch
    • The sunroof control module
    • The sunroof actuator
    • The sunroof opening position switch
  3. Install new nylon tie straps to the sunroof control module and the drive cable tube.
  4. Install new tape to hold the wire harness to the module.
  5. Inspect for proper operation of the sunroof.
  6. Install the rear shelf. Refer to Rear Window Shelf Trim Panel Replacement .
  7. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals