LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Sunroof System) >> Repair Instructions >> Sunroof Window Height and Opening Fit Adjustment

Sunroof Window Height and Opening Fit Adjustment

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Adjusting Sunroof Window Panel
    GM294274Courtesy of GENERAL MOTORS CORP.
  1. Slide the sunroof sunshade to the open position.
  2. Adjust the sunroof to the fully closed position.
  3. Loosen the sunroof window panel screws.
  4. Individually adjust the 4 corners of the sunroof window panel.
  5. Adjust the front of the sunroof window panel to 0.5 mm (0.020 in) below the top surface (3) of the roof panel.
  6. Adjust the rear of the sunroof window panel to 0.5 mm (0.020 in) above the top surface (2) of the roof panel.
    7. Fig 2: View Of Sunroof Window Panel Screws
    GM294278Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  7. Tighten the sunroof window panel screws.

    Tighten:  Tighten the sunroof window panel screws to 4 N.m (35 lb in).

  8. Close the sunshade.
scientia non olet · About LEMON Manuals