LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Seat Belt Buckle Pretensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the pretensioner to the seat bottom frame.
  2. Position the wiring harness to the seat belt pretensioner through the seat bottom frame.
  3. Connect the pretensioner electrical connector to the seat electrical harness.
  4. If equipped, connect the seat belt reminder cable.
    5. Fig 1: Locating Seat Belt Buckle Pretensioner
    GM858954Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the nut to the seat belt pretensioner.

    Tighten:  Tighten the nut to 35 N.m (26 lb ft).

    6. Fig 2: Identifying Position Assurance Pin & Pretensioner Electric Connector
    GM858956Courtesy of GENERAL MOTORS CORP.
  6. Install the pretensioner electric connector (1) and position assurance pin (2) to the body harness.
  7. Connect the seat harness connector to the body harness.
  8. Install the driver seat belts. Refer to Front Seat Replacement - Bucket .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
  10. If the pretensioner is to be scrapped, deploy the pretensioner. Refer to Pretensioner Handling and Scrapping .
  11. If the pretensioner is to be returned undeployed to the manufacturer for warranty, refer to Pretensioner Handling and Scrapping .
scientia non olet · About LEMON Manuals