Circuit/System Testing
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- The Passenger AIR BAG ON/OFF indicator
- The PPS module
- The Passenger AIR BAG ON/OFF indicator wiring harness connector
- The PPS wiring harness connector
- Ignition OFF, disconnect the PPS module connector located under the passenger seat.
- Disconnect the Passenger AIR BAG ON/OFF Indicator connector.
- Test the Passenger AIR BAG ON/OFF indicator ignition 1 voltage circuit for a short to ground, a high resistance, or an open. Verify that a short to ground, a high resistance, or an open does not exist.
- If any of the above conditions are found make the appropriate repair.
- Test both ON and OFF indicator control circuits between the Passenger AIR BAG ON/OFF indicator and the PPS for a short to voltage, high resistance, or an open. Verify that a short to voltage, a high resistance, or an open does not exist.
- If any of the above conditions are found make the appropriate repair.
- Reconnect the PPS connector then turn the ignition ON, engine OFF. Then connect a test lamp between the ignition 1 voltage circuit and Passenger Air Bag OFF indicator control circuit on the Passenger AIR BAG ON/OFF indicator connector. With the passenger front seat empty verify the test lamp illuminate.
- If test lamp does not illuminate replace the PPS.
- If test lamp illuminate replace the Passenger AIR BAG ON/OFF Indicator.
IMPORTANT:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.