LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1001 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the scan tool BCM VIN Information matches the vehicle VIN.
    • If the VINs do not match, reprogram the BCM.
  2. Perform the SDM Setup SDM Part Number into BCM procedure.
  3. With a scan tool, verify DTC B1001 is not set as current.
    • If DTC B1001 is current replace the SDM.
scientia non olet · About LEMON Manuals