LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0100, B0101, B0102, B0103, B0104, or B0105 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
    • The front end sensor
    • The SDM module
    • The front end sensor wiring harness connector
    • The SDM wiring harness connector
  1. Ignition ON, use the scan tool as clear SIR codes then recheck for DTCs. Verify that DTC B0101, B0102, B0104, or B0105 is not set.
    • If DTC B0101 or B0102 is set current replace the front end sensor 1/left.
    • If DTC B0104 or B0105 is set current replace the front end sensor 2/right.
  2. If DTC B0100 is current, disconnect the front end sensor 1 connector, or if DTC B0103 is current disconnect the front end sensor 2 connector.
  3. Remove the SDM connector.
  4. Test the signal and voltage circuits between the SDM and front end sensor. Verify that a short to voltage, short to ground, or open/low resistance does not exist.
    • If any of the above conditions are found make the appropriate repair.
  5. Reconnect all SIR components. Ignition ON, use the scan tool to clear the DTCs then recheck for DTCs. Verify no DTCs are set.
    • If DTC B0100 was current replace the front end sensor 1. After replacement refer to Repair Verification .
    • If DTC B0103 was current replace the front end sensor 2. After replacement refer to Repair Verification .
scientia non olet · About LEMON Manuals