LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0098 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
    • The PPS module
    • The SDM module
    • The PPS wiring harness connector
    • The SDM wiring harness connector
  1. Check to see if the PPS was replaced. Verify the correct PPS was installed.
    • If the wrong PPS was installed, replace with the correct PPS.
  2. Check to see if the SDM was replaced. Verify the correct SDM was installed.
    • If the wrong SDM was installed, replace with the correct SDM.
  3. Check to see if DTC B1001 is set. Verify DTC B1001 is not set.
    • If the connector for the PPS is damaged, the PPS must be replaced.
    • If DTC B1001 is current go to DTC B1001 .
  4. Replace the PPS. Ignition ON, use the scan tool to clear the DTCs then recheck for DTC B0098. Verify DTC B0098 does not set.
    • If DTC B0098 resets then replace the SDM.
scientia non olet · About LEMON Manuals