Headlamp Assembly or Headlamp Bulb Replacement

Fig 1: Headlamp Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	NOTE: Refer to Fastener Notice . Preliminary Procedure: Loosen either the LF or RF bumper fascia corner in order to flex the fascia when removing the headlamp assembly. Refer to Front Bumper Fascia Replacement .Headlamp Retainer Bolt Tighten: Tighten the retainer bracket bolt to 10 N.m (89 lb in)
2	Headlamp Retainer Tip: Lift the retainer straight upward in order to release the headlamp assembly from the headlamp mounting panel.
3	Headlamp Retainer Tip: Lift the retainer straight upward in order to release the headlamp assembly from the headlamp mounting panel.
4	Headlamp Assembly Tip: Carefully pull the headlamp assembly forward and disconnect the electrical harness connector