LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Terraza CX, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Carrier Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Bolts/Screws For IP Carrier And Cross Vehicle Beam To Hinge Pillar
    GM482588Courtesy of GENERAL MOTORS CORP.
  1. Position the I/P carrier to the body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts/screws which secure the I/P carrier to the body.

    Tighten:  Tighten the bolts/screws to 25 N.m (18 lb ft).

  3. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the right side window defogger duct.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  4. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the left side window defogger duct.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  5. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located on the rear right center of the I/P carrier.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  6. Install the bolt holding the brake pedal bracket on the I/P carrier, this bolt is located on the upper rear side of the bracket.

    Tighten:  Tighten the bolts/screws to 25 N.m (18 lb ft).

  7. Install the ground wire bolts on the lower I/P carrier on the right and left sides.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  8. Install the bolts holding the steering column support bracket on the cowl panel brace.

    Tighten:  Tighten the bolts/screws to 24 N.m (18 lb ft).

  9. Install the defroster duct. Refer to Air Outlet Duct Replacement - Defroster in Heating Ventilation and Air Conditioning.
  10. Install the center air outlet. Refer to Air Outlet Replacement - Center in Heating, Ventilation and Air Conditioning.
  11. Install the I/P air outlet ducts. Refer to Instrument Panel (I/P) Air Outlet Ducts Replacement in Heating, Ventilation and Air Conditioning.
  12. Install the A/C control module. Refer to HVAC Control Module Replacement in Heating, Ventilation and Air Conditioning.
  13. Install the EBCM. Refer to Electronic Brake Control Module Replacement in Antilock Brake System.
  14. Install the BCM.
  15. Install the wiring harness. Refer to Instrument Panel (I/P) Harness Replacement .
  16. Install the I/P. Refer to Instrument Panel (I/P) Assembly Replacement .
  17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  18. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in SIR.
scientia non olet · About LEMON Manuals