LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Removal Procedure

Removal Procedure

    Fig 1: IPC & Screws
    GM326089Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster (IPC).
  1. Remove the cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
  2. Remove the screws from the IPC.
  3. In order to remove the IPC, perform the following procedures:
    1. Rotate the top of the cluster rearward.
    2. Disengage the locating pins on the bottom of the cluster.
    4. Fig 2: IPC Electrical Connector
    GM326091Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the cluster.
scientia non olet · About LEMON Manuals