Installation Procedure

Fig 1: I/P Lower Trim Outer Filler Panel

Courtesy of GENERAL MOTORS CORP.

Position the filler panel retainers into the openings in the trim pad.
Starting at the bottom, install the filler panel by pressing in at each retainer location until correctly seated.

Fig 2: I/P Lower Trim Outer Filler Panel Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the filler panel bolt.
Tighten: Tighten the bolt to 2 N.m (18 lb in).
Close the I/P compartment.
Install the lower pillar garnish molding. Refer to Garnish Molding Replacement - Lower Pillar in Interior Trim.