Diagnostic Aids
Use the Freeze Frame and/or Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data may aid in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also aid in determining the number of ignition cycles that the diagnostic reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, i.e. RPM, load, vehicle speed, temperature, etc. This will isolate when the DTC failed.
Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
DTC B0600
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Using a scan tool, clear DTC B0600. Does DTC B0600 reset? |
Go to Step 3 | System OK |
| 3 | Replace the instrument cluster. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement? |
Go to Step 4 | - |
| 4 | Use the scan tool in order to clear the DTCs. Operate the vehicle within the conditions for running the DTC as specified in the supporting text. Does the DTC reset? |
Go to Step 2 | System OK |