LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Chime Inoperative

Chime Inoperative

Chime Inoperative

Step Action Yes No
Schematic Reference: Audible Warnings Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. With a scan tool, perform the Chime Test in the BCM.
Does the chime sound?		 Go to Step 3  Go to Step 10 
3
  1. Turn the ignition OFF.
  2. Open the driver door.
Do the courtesy lamps illuminate when the driver's door is opened?		 Go to Step 4  Go to Courtesy Lamps Inoperative in Lighting Systems
4
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Turn the headlamp switch to park.
  4. With a scan tool, observe the LCM Lights On Chime parameter in the BCM Inputs data list.
Does the LCM Lights On Chime parameter display On?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 5 
5
  1. Turn OFF the ignition.
  2. Disconnect the body control module (BCM) connector C3.
  3. Connect a test lamp between the exterior lamp off signal circuit and a good ground.
  4. Turn the headlamp switch to park.
Does the test lamp illuminate?		 Go to Step 6  Go to Step 8 
6 Test the park lamp off signal circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 7 
7 Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 9 
8 Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 10 
9 Replace the headlamp switch. Refer to Headlamp Switch Replacement in Lighting Systems.
Did you complete the replacement?		 Go to Step 11  -
10 Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 11  -
11 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals