LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 5 Of 5) >> Off-Vehicle Repair Instructions - Part 4 >> Drive Belt Idler Pulley Installation

Drive Belt Idler Pulley Installation

    Fig 1: Drive Belt Idler Pulley
    GM1395910Courtesy of GENERAL MOTORS CORP.
  1. Place the drive belt idler pulley and bolt in position through the generator mounting hole and into the engine front cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

  3. Tighten the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals