LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 4 Of 5) >> Off-Vehicle Repair Instructions - Part 3 >> Crankshaft Sprocket Installation >> Installation Procedure

Installation Procedure

    Fig 1: Locating Crankshaft Sprocket Timing Mark
    GM1306405Courtesy of GENERAL MOTORS CORP.
  1. Ensure the crankshaft sprocket is installed with the timing mark (1) visible.
    2. Fig 2: Crankshaft Sprocket
    GM902842Courtesy of GENERAL MOTORS CORP.
  2. Install the crankshaft sprocket on to the nose of the crankshaft.
  3. Align the notch in the crankshaft sprocket with the pin in the crankshaft.
  4. Slide the crankshaft sprocket on the crankshaft nose until the crankshaft sprocket contacts the step in the crankshaft.
    5. Fig 3: Aligning The Crankshaft Sprocket To The Stage One Timing Drive Assembly Position
    GM1306406Courtesy of GENERAL MOTORS CORP.
  5. If necessary, align the crankshaft sprocket to the stage one timing drive assembly position using the EN 46111  . Refer to Camshaft Timing Drive Chain Alignment Diagram (With Primary Roller Chain) or Camshaft Timing Drive Chain Alignment Diagram (W/Primary (IT) Inverted Tooth Chain) - Stage One.
scientia non olet · About LEMON Manuals