LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 4 Of 5) >> Off-Vehicle Repair Instructions - Part 3 >> Camshaft Position (CMP) Actuator Installation - Left Intake

Camshaft Position (CMP) Actuator Installation - Left Intake

    NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.
  1. Use an open wrench on the hex cast into the camshaft in order to prevent camshaft rotation when tightening the camshaft position actuator bolt.
    2. Fig 1: Removing/Installing Camshaft Position (CMP) Actuator
    GM946219Courtesy of GENERAL MOTORS CORP.
  2. Install the left intake camshaft position actuator.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the camshaft position actuator bolt.

    Tighten:  Tighten the camshaft position actuator bolt to 58 N.m (43 lb ft).

scientia non olet · About LEMON Manuals