Console Replacement - Front Floor
Console Replacement - Front Floor
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
in Cautions and Notices. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the rear floor console. Refer to Console Replacement - Rear Floor . |
|
| 1 | Trim Plate, Instrument Panel Lower Tip: Set the parking brake, then shift the transmission into drive and push the shift indicator down until it locks, to allow clearance to remove the console. |
| 2 | Screw, Front Floor Console Trim Plate (Qty: 2) Tighten: 2 N.m (18 lb in) |
| 3 | Bolt, Front Floor Console Bracket (Qty: 2) Tighten: 10 N.m (88 lb in) |
| 4 | Console Assembly, Front Floor Front Tip: Pull the front console side panels outboard at the front of the console to disengage the retaining clips from the instrument panel. |